Schumacher Battery Charger PSC 2516A User Guide

Model: PSC-2516A  
25 AMP Fully Automatic Battery Charger  
For 16 Volt AGM Batteries  
INSTRUCTION MANUAL  
–Save–  
Important Safety Instructions  
Read Rules for Safe Operation and Instructions Carefully  
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal  
battery operation. For this reason, it is of utmost importance that each time before using your charger, you  
read this manual and follow the instructions exactly.  
WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a  
chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.  
A.  
GENERAL BATTERY SAFETY  
• Pins on plug of extension cord are the same number,  
size, and shape as those of plug on charger.  
• Extension cord is properly wired and in good electrical  
condition.  
1. Before you use your battery charger, be sure to read all  
instructions and cautions printed on:  
• Battery Charger  
• Battery  
• Wire size is large enough forAC ampere rating of charger,  
as specified below:  
• Vehicle or unit using battery  
2. Use battery charger on LEAD ACID type rechargeable  
batteries only, such as used on race cars. Charger is not  
intended to supply power to low-voltage electrical system  
other than in an automotive application.  
Length of cord (feet):  
AWG size of cord:  
25  
18  
50  
16  
100  
12  
150  
10  
WARNING: Do not use battery charger for charging dry-  
cell batteries that are commonly used with home appliances.  
These batteries may burst and cause injury to persons and  
damage to property.  
11. Always charge battery in a well-ventilated area.  
NEVER operate in a closed-in or restricted area without  
adequate ventilation.  
3. Use only attachments recommended or sold by  
manufacturer. Use of non-recommended attachments may  
result in fire, electric shock, or injury.  
WARNING: Risk of explosive gas.  
12. Locate charger as far away from battery as DC charger  
cables permit.  
4. When disconnecting the battery charger, pull by the plug  
not by the cord. Pulling on the cord may cause damage to  
cord or plug.  
5. Locate battery power cord so it cannot be stepped on, tripped  
over, or subjected to damage or stress.  
13. Do not expose charger to rain or snow.  
14. NEVER charge a frozen battery. If battery fluid (electrolyte)  
is frozen, bring into a warm area to thaw before charging.  
15. NEVER allow battery acid to drip on charger when reading  
specific gravity or filling battery.  
6. Do not operate charger with damaged cord or plug. Have  
cord replaced immediately.  
16. NEVER set a battery on top of charger.  
17. NEVER place charger directly above battery being charged.  
Gases from battery will corrode and damage charger.  
18. NEVER touch the battery clamps together when the charger  
is energized.  
19. NEVER crank engine with charger attached to battery.  
WARNING: Battery chargers get hot during operation and  
must have proper ventilation. Air needs to flow around entire  
charger. Do not set on flammable items like carpeting,  
upholstery, paper, cardboard, etc. Will damage leather and  
melt plastic and rubber.  
7. Do not operate charger if it has received a sharp blow, been  
dropped, or otherwise damaged in any way. Take it to a  
qualified professional for inspection and repair.  
8. Do not disassemble charger. Take it to a qualified  
professional when service or repair is required. Incorrect  
reassembly may result in electric shock or fire.  
9. To reduce risk of electric shock, unplug charger from outlet  
before attempting any maintenance or cleaning.  
10. Do not use an extension cord unless absolutely necessary.  
Use of an improper extension cord could result in fire or  
electric shock. If an extension cord must be used, make  
sure that:  
Send Warranty Product Repairs to: Schumacher Electric Corporation, 1025 E. Thompson, Hoopeston, IL 60942-0280  
Call Customer Service if you have questions: 1-800-621-5485  
00-99-000540/0705  
1
 
F.  
OPERATING INSTRUCTIONS: CHARGING BATTERY OUT OF THE VEHICLE  
When charging battery out of the vehicle, take care to determine the battery type. To reduce risk of a spark near battery, follow these  
steps when battery is outside vehicle. WARNING: A spark near battery may cause battery explosion. WARNING: When removing battery  
from vehicle or boat, disconnect grounded post first. When disconnecting, make sure all accessories are off, so as not to cause an arc.  
(NOTE: A marine (boat) battery must be removed and charged on shore. (To charge on board requires special equipment designed for  
marine use.) WARNING: When reinstalling battery, attach the ground post first.  
1. Perform these steps with the ON/OFF switch in the OFF  
NEGATIVE  
POSITIVE  
position.  
BATTERY CHARGER  
2. Check polarity of battery posts. Battery case will be marked  
BATTERY  
by each post: POSITIVE (POS, P, +) and NEGATIVE (NEG,  
N, -). NOTE: The positive battery post usually has a larger  
+ -  
diameter than the negative post.  
POWER  
CORD  
24", 6 GUAGE  
CABLE  
3. Attach a 24-inch long (or longer) 6-gauge (AWG) insulated  
battery cable to NEGATIVE (NEG, N, -) battery post.  
(Purchase cable separately.)  
TO GROUNDED  
POWER OUTLET  
4. Connect POSITIVE (RED) charger clamp to POSITIVE  
(POS, P, +) battery post. Rock clamp back and forth to  
make good connection.  
FIGURE 1: CONNECT NEGATIVE BATTERY CLAMP  
TO 24-INCH CABLE END  
5. Position yourself and free end of 24-inch cable as far away  
from battery as possible. Then connect NEGATIVE (BLACK)  
charger clamp to free end of cable. WARNING: Do not face  
battery when making final connection. Rock clamp back  
and forth to make a good connection.  
8. When battery is fully charged, push ON/OFF switch to OFF,  
unplug charger from AC power source.  
9. When battery is fully charged and charger is unplugged,  
(1) remove clamp from end of 24-inch long cable connected  
to NEGATIVE battery post, then (2) remove clamp from  
Positive battery post, in that order.  
FIGURE 1 shows the connection.  
6. Plug charger AC cord into 120 volt outlet.  
7. Select ON position on ON/OFF switch.  
10. Clean and store battery charger.  
G.  
OPERATING INSTRUCTIONS: CHARGING BATTERY IN VEHICLE  
When charging battery in vehicle, take care to determine the battery type and which pole is grounded. To reduce risk of a spark near  
battery, follow these steps when battery is inside vehicle. WARNING: A spark near the battery may cause battery explosion.  
1. Perform these steps with the ON/OFF switch in the OFF  
GR
(
position.  
2. Position AC power cord and DC charging cords to reduce  
risk of damage by hood, door, or moving engine parts.  
3. Stay clear of fan blades, belts, pulleys, and other parts that  
can cause injury.  
4. Check polarity of battery posts. Battery case will be marked  
by each post: POSITIVE (POS, P, +) and NEGATIVE (NEG,  
N, -). NOTE: The positive battery post usually has a larger  
diameter than the negative post.  
FIGURE 2: CONNECTION TO NEGATIVE  
GROUNDED BATTERY  
5. Determine which post of battery is grounded (connected)  
POSITIVE GROUNDED POST  
to chassis. NOTE: The negative post is normally grounded.  
6B. For positive-grounded vehicle, connect NEGATIVE (BLACK)  
clamp from battery charger to NEGATIVE (NEG, N, -)  
ungrounded post of battery. Connect POSITIVE (RED)  
clamp to vehicle chassis or engine block away from battery.  
Connect to a heavy-gauge metal part of the frame or engine  
block.  
NEGATIVE GROUNDED POST  
6A. For negative-grounded vehicle, connect POSITIVE (RED)  
clamp from battery charger to POSITIVE (POS, P, +)  
ungrounded post of battery. Connect NEGATIVE (BLACK)  
clamp to vehicle chassis or engine block away from battery.  
Connect to a heavy-gage metal part of the frame or engine  
block.  
7. Plug charger AC cord into a grounded 120 volt outlet.  
8. Select the ON position on the ON/OFF switch.  
WARNING: Do not connect clamp to carburetor, fuel lines,  
or sheet-metal body parts. NOTE: Attach clamps to battery  
post and twist or rock back and forth several times to make  
a good connection. This tends to keep clamps from slipping  
off terminals and helps to reduce risk of sparking.  
9. When battery is fully charged, push the ON/OFF switch to  
OFF, unplug charger from AC power source.  
10. Remove charger clamps from (1) chassis and (2) battery  
post, in that order.  
FIGURE 2 shows connections for a negative-grounded  
battery.  
11. Clean and store battery charger.  
3
 
H.  
TROUBLESHOOTING  
PROBLEM  
POSSIBLE  
SOLUTION  
Red LED doesn't light  
Charger is not plugged in  
AC outlet is dead.  
Plug in.  
Plug in a lamp or other appliance to check for  
voltage.  
Charger will not turn ON when  
properly connected to power.  
Battery recently used in vehicle and is  
fully charged.  
Battery doesn't need charging.  
Have battery checked.  
Charger will not turn OFF.  
Battery has problem and will not take  
full charge.  
Battery is connected to application that  
draws a small current (such as a  
vehicle's dome light).  
Requires more time to charge: continue  
charging..  
I.  
MAINTENANCE/CLEANING INSTRUCTIONS  
Little maintenance is required for the battery charger.  
3. Have any cracked or frayed cords replaced by a qualified  
professional.  
1. After use, wipe all battery corrosion and other dirt or oil  
from clamps, cord, and the charger case. Use a dry cloth.  
4. Store battery charger in a clean, dry area.  
2. Coil charger cords to prevent damage.  
LIMITED WARRANTY  
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND  
THE MANUFACTURER NEITHER ASSUMES NOR  
AUTHORIZESANYONE TOASSUME OR MAKEANY OTHER  
OBLIGATION TOWARDS THE PRODUCT OTHER THAN  
DSR CORPORATION, 801 BUSINESS CENTER DRIVE,  
MOUNT PROSPECT, ILLINOIS, 60056-2179 MAKES THIS  
LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT  
RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS  
NOT TRANSFERABLE.  
THIS  
EXPRESS  
LIMITED  
WARRANTY.  
THE  
MANUFACTURER MAKES NO WARRANTY OF  
MERCHANTABILITY OR FITNESS FOR PURPOSE OF THIS  
PRODUCTAND EXPRESSLY EXCLUDES SUCH FROM THIS  
LIMITED WARRANTY.  
DSR Corporation warrants this battery charger for one year  
from date of purchase at retail against defective material or  
workmanship. If such should occur, the unit will be repaired  
or replaced at the option of the manufacturer. It is the obligation  
of the purchaser to forward the unit together with proof of  
purchase, transportation and/or mailing charges prepaid to  
the manufacturer or its authorized representative.  
SOME STATES DO NOT ALLOW THE EXCLUSION OR  
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL  
DAMAGES OR LENGTH OF IMPLIED WARRANTY SO THE  
ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY  
TO YOU.  
This limited warranty is void if the product is misused,  
subjected to careless handling, or repaired by anyone other  
than the manufacturer or its authorized representative.  
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS  
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY  
FROM STATE TO STATE.  
The manufacturer makes no warranty other than this limited  
warranty and expressly excludes any implied warranty  
including any warranty for consequential damages.  
4
 

Q See Home Security System QPSCDNV User Guide
Radio Shack Telephone System 350 User Guide
Rockford Fosgate Car Amplifier T2500 1bd User Guide
Rotel CD Player RCD 02 User Guide
Russound Car Stereo System CAM66T S1 User Guide
Samsung Digital Camera EC WB30FZBPBUS User Guide
Samsung DVR SMT 190 User Guide
Schlage Door BA360 User Guide
Sears Automobile Battery Charger 2871222 User Guide
Sears CRT Television 2744394859 User Guide