Samsung Network Router SCS 26UC4 User Guide

Verizon Wireless Network Extender  
Quick Start Guide  
EP68-00361A  
SCS-26UC4  
 
Power  
LED  
Wireless  
Antenna  
GPS  
Antenna  
System  
LED  
Heat  
Vents  
DC12V  
Power  
Port  
GPS  
LED  
WAN  
Port  
WAN  
LED  
 
CONNECTING YOUR NETWORK EXTENDER  
1. The Network Extender needs to be located:  
Near a window (if this is not possible, see  
“External GPS Antennain the User Manual)  
1HWZRUNꢀ([WHQGHU  
At least two feet away from your router if it  
supports Wi-Fi  
For best results, place the Network Extender  
in an elevated location, such as the top of a  
bookshelf or tall cabinet.  
3RZHUꢀ6XSSO\  
3RZHUꢀ&RUG  
2. Connect one end of the included Ethernet  
cable to an open port on the router (1) and  
connect the other end to the WAN port lo-  
cated at the rear of the base station (2).  
(WKHUQHWꢀ&DEOH  
5RXWHU  
3. Plug the power supply connector into the DC  
12V power port located at the rear of the base  
station (3).  
4. Insert one end of the power cord into the  
power supply and then plug the other end  
into an available outlet (4).  
 
5. Allow 3 - 5 minutes for the base station  
to complete the startup sequence and  
detect both its connections and available  
communications. The first time the base  
station is used, it may take as long as one  
hour for the initial GPS acquisition.  
CONFIRMING NETWORK EXTENDER  
OPERATION  
LED  
Function  
Description  
PWR  
Power  
Solid blue: normal  
No light: abnormal  
Your Network Extender is ready for use when all  
four LEDs are solid blue.  
SYS  
System  
Solid blue: normal  
Blinking red: establishing  
an initial network  
connection  
connected  
Note: The optional GPS antenna cable is required  
only when the external GPS antenna installation  
is necessary.  
Solid red: abnormal  
GPS  
GPS Signal  
Solid blue: normal (GPS  
signal is received)  
Blinking blue or red:  
while searching for GPS  
signal  
Solid red: abnormal  
(GPS signal cannot be  
received, the external  
GPS antenna is required)*  
WAN  
WAN (Ethernet Solid blue: normal  
connection)  
Blinking blue: data  
communication  
No light: abnormal  
* See “External GPS Antennain the User Guide.  
 
FOR MORE INFORMATION  
TROUBLESHOOTING  
Refer to the Network Extender User Guide  
that came with your device.  
What if my GPS LED is still red after one hour?  
If the GPS LED is still red after one hour, you need  
to relocate the GPS antenna to receive a stronger  
signal. See “External GPS Antennain the User  
Guide.  
Visit verizonwireless.com/support  
Call Customer Service toll free at 800-922-  
0204 or *611 from your Verizon Wireless  
mobile phone.  
How do I know my phone is connecting  
through the Network Extender?  
#
When dialing 48 on your wireless phone, an an-  
nouncement will tell you if you are within range  
of the Network Extender. In addition, you will  
hear a short double tone on your wireless phone  
whenever making or receiving a call. The tone is  
played at the beginning of the call.  
© 2009 Verizon Wireless. All rights reserved. Verizon Wireless is a  
trademark of Verizon Trademark Services LLC.  
 

Quatech Network Card SPPXP 100 User Guide
Roberts Radio Portable Radio ClassicLite User Guide
Roland Recording Equipment VC 1 D 50 User Guide
Ryobi Drill DP101 User Guide
Samson Headphones SWC99BGT K; SWC99BGT I User Guide
Samsung All in One Printer SCXFIN20S User Guide
Samsung Home Theater System HT DB1650 User Guide
Samsung Printer 3560 User Guide
Sanyo Battery Charger CP 3600CR User Guide
Sennheiser Headphones HD 224 X User Guide