Radio Shack Stereo Receiver 15 124 User Guide

using your receiver  
rf emissions information  
This equipment has been tested and found to comply with  
the limits for a Class B digital device, pursuant to part 15  
of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a  
residential installation. This equipment generates, uses and  
can radiate radio frequency energy and, if not installed and  
used in accordance with the instructions, may cause harmful  
interference to radio communications.  
Your receiver works with the transmitter of your  
2.4 GHz USB Connection Digital Audio Link.  
Refer to the user’s guide of your 2.4 GHz USB  
Connection Digital Audio Link before using your  
receiver.  
15-124  
2.4 GHz Digital Audio Receiver  
However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the  
user is encouraged to try to correct the interference by one or  
more of the following measures:  
Thank you for purchasing your 2.4 GHz Digital  
Audio Receiver from RadioShack. This add-on  
receiver is designed for use with your 2.4 GHz USB  
Connection Digital Audio Link.  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and  
receiver.  
Connect the 3.5mm stereo  
Y-type cable or 3.5mm stereo  
audio cable, then connect the  
other end to your stereo’s  
audio input jacks.  
Connect the 9V AC  
adapter, then plug  
the other end into a  
standard AC outlet.  
• Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
Consult your local RadioShack store or an experienced  
radio/TV technician for help. If you cannot eliminate the  
interference, the FCC requires that you stop using your  
receiver. Changes or modifications not expressly approved  
by RadioShack may cause interference and void the user’s  
authority to operate the equipment.  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions: (1) this device  
may not cause harmful interference, and (2) this device must  
accept any interference received, including interference that  
may cause undesired operation.  
To avoid injury, do not connect the provided  
power adapter to a ceiling outlet.  
Notes  
Power indicator  
Lights when your  
transmitter (not supplied)  
and receiver link.  
Use only an adapter that supplies 9V DC and  
delivers at least 200mA. Its center tip must be  
set to positive.  
• Unplug the AC adapter from the AC outlet  
before unplugging from the receiver.  
• For better performance and greater reception  
range, keep the receiver and transmitter away  
from wireless LAN access points, microwave  
ovens, and wireless networks or phones that  
run on 2.4 GHz frequency.  
2.4 GHz  
Product  
what’s included  
Digital Audio Receiver  
Receiver  
Model  
15-124  
AC Adapter  
RadioShack  
300 RadioShack Circle  
Fort Worth,TX 76102  
Responsible  
Party  
specifications  
3.5mm Stereo Y-Type Patch Cable  
3.5mm Stereo Audio Cable  
User’s Guide  
Frequency Range ...................................................2.4 ~ 2.4835 GHz  
Channel Frequency ..................................... 2410, 2419 ~ 2473 MHz  
Channel Spacing ...................................................................... 9 MHz  
Frequency Stability ............................................................... ±1 MHz  
Transmission Range........................45 ft (15 m, in the home) (Max.)  
.................................................... 100 ft (30.5 m, line of sight) (Max.)  
Operating Temperature........................... 32°F to 104°F (0°C to 40°C)  
Power Supply ...................................... 120VAC/60Hz, 9V DC/200mA  
Response................................................................ 20 ~ 20kHz±3dB  
S/N Ratio...........................................................................40dB (Min.)  
Sensitivity ................................................................. −85 dBm (Min.)  
Output Impedance ........................................... >10K Ohm (3.5 mm)  
Output Level...................................................................2 Vms±10%  
Dimensions (H x W x D).......................................3.4 x 3.4 x 1.3 Inch  
...............................................................................(86 x 86 x 32 mm)  
Weight............................................................................2.29 oz (65 g)  
Phone  
817-415-3200  
limited 90-day warranty  
Please read this user’s guide before  
installing, setting up, and using your new receiver.  
This product is warranted by RadioShack against manufacturing defects  
in material and workmanship under normal use for ninety (90) days from the  
date of purchase from RadioShack company-owned stores and authorized  
RadioShack franchisees and dealers. For complete warranty details and  
exclusions, check with your local RadioShack store.  
RadioShack Customer Relations  
300 RadioShack Circle, Fort Worth, TX 76102  
©2007. RadioShack Corporation.  
Specifications are subject to change and improvement without  
notice. Actual product may vary from the images found in this  
document.  
04/04  
All rights reserved. RadioShack and  
RadioShack.com are trademarks  
used by RadioShack Corporation.  
15-124  
02A07  
Printed in China  
 

RedMax Brush Cutter BCZ2610S User Guide
Reebok Fitness Home Gym RBEL99062 User Guide
Regency Indoor Fireplace P42 LP3 User Guide
Renesas Computer Hardware H8SX 1648 User Guide
Ricoh Printer DSc424 User Guide
RIDGID Camping Equipment AM2500 User Guide
Roberts Radio Radio CRD 39 User Guide
Sakar Digital Camera 16382 User Guide
Samson Stereo Amplifier S62 User Guide
Sanyo Battery Charger UF653048P User Guide