Radio Shack Door 63 984 User Guide

63-984.fm Page 1 Wednesday, September 8, 1999 4:42 PM  
Cat. No. 63-984  
Wireless Intercom Door Chime  
Your RadioShack Wireless Intercom  
Door Chime operates as a two-tone  
doorbell and an intercom. The chime  
is simple to install because it requires  
no wiring. Your chime's two channel  
switch and digital coding prevent other  
transmitters or radio devices from  
sounding the chime. To conserve  
power, both the receiver and transmit-  
ter automatically turn off 30 seconds  
after you stop using them.  
Indicators — light so you can easily  
confirm the chime’s operation.  
To reduce the risk of fire or  
shock hazard, do not expose this product to rain  
or moisture.  
WARNING:  
CAUTION  
RISK OF ELECTRIC SHOCK.  
!
DO NOT OPEN.  
TO REDUCE THE RISK OF  
CAUTION:  
ELECTRIC SHOCK, DO NOT REMOVE  
COVER OR BACK. NO USER-SERVICE-  
ABLE PARTS INSIDE. REFER SERVICING  
TO QUALIFIED PERSONNEL.  
The chime includes these features:  
Separate Buttons for Bell and Inter-  
com — let your callers first announce  
their arrival and then communicate us-  
ing the intercom.  
This symbol is intended to alert  
you to the presence of uninsu-  
lated dangerous voltage within  
the product’s enclosure that might  
be of sufficient magnitude to con-  
stitute a risk of electric shock. Do  
not open the product’s case.  
Receiver Volume Control — lets you  
adjust the volume to a comfortable lev-  
el.  
This symbol is intended to inform  
you that important operating and  
maintenance instructions are  
included in the literature accom-  
panying this product.  
2-Channel Transmitter and Receiv-  
er with Digital Code Selection — as-  
sure interference-free communication.  
!
50-Foot Usable Operation Distance  
— means you can install the transmit-  
ter and receiver virtually anywhere in  
your home or business.  
©
1999 Tandy Corporation.  
All Rights Reserved.  
RadioShack is a registered trademark used by Tandy Corporation.  
 
63-984.fm Page 3 Wednesday, September 8, 1999 4:42 PM  
2. Place the batteries into the battery  
compartment as indicated by the  
polarity symbols (+ and –) marked  
inside.  
BELL on the transmitter. The chime  
should sound.  
BELL  
3. Be sure the rubber seal around the  
battery compartment is properly  
positioned, then replace the cover  
and tighten the screw.  
Replace all four batteries if the transmit-  
ter’s indicator lights dimly or not at all  
when you press any button on the trans-  
mitter.  
2. If the chime does not sound, make  
certain that the transmitter and re-  
ceiver are set to the same channel  
and code.  
Warning: Dispose of old batteries  
promptly and properly. Do not burn or  
bury them.  
3. Adjust VOLUME on the receiver to  
the desired listening level.  
Mounting the Transmitter  
Caution: If you do not plan to use the  
door chime for a two week period, re-  
move the batteries. Batteries can leak  
chemicals that can destroy electronic  
parts.  
Mount the transmitter within 50 feet of  
the receiver using the supplied mounting  
hardware. Depending upon the mount-  
ing surface material of your home (wood  
siding, brick face, and so on), you might  
onsult your local hardware  
need to c  
store for a different type of mounting  
hardware.  
Testing the Chime  
Before permanently mounting the  
chime, follow these steps to test the sys-  
tem  
Note: While the transmitter is water-  
resistant, it is not waterproof. If you  
are mounting the transmitter out-  
doors, select a location that provides  
some shielding from the elements.  
1. With the receiver plugged into a  
standard AC outlet, adjust VOLUME  
to its middle position. Then press  
Follow these steps to mount the trans-  
mitter.  
3
16  
1. Drill four / -inch diameter holes into  
the mounting surface (as shown be-  
3
 
63-984.fm Page 4 Wednesday, September 8, 1999 4:42 PM  
low). Then insert an anchor into  
each hole.  
4. Once the transmitter is securely on  
the bracket, insert the two supplied  
pan-head machine screws through  
the two holes on the lower edge of  
the transmitter and into the threaded  
holes in the bracket.  
3/16 Inch Diameter Hole  
50mm  
85mm  
2. Align the metal mounting bracket  
with the holes you just drilled and  
drive a screw through the bracket  
into each hole. Do not overtighten  
the screws.  
Mounting the Receiver  
To mount the receiver onto a typical  
sheetrock wall, use the two supplied pan  
washer screws and anchors. Other-  
wise, consult your local hardware store  
for suitable hardware.  
3
16  
1. Drill two / -inch diameter holes into  
3
16  
the mounting surface about 4 /  
inches (106 mm) apart  
3. Align the slot on the back of the  
transmitter with the hook on the  
mounting bracket. Carefully push  
the transmitter onto the hook and  
slide it down to secure it.  
2. Insert an anchor into each drilled  
hole, then thread a screw into each  
anchor, letting the head of each  
1
8
screw extend about / inch from the  
wall.  
1/8 Inch  
4
 
63-984.fm Page 5 Wednesday, September 8, 1999 4:42 PM  
3. Route the AC power cord beneath  
the tabs on either side of the chan-  
nel on the back of the receiver  
CARE  
To use your RadioShack Wireless Inter-  
com Door Chime system for a long time:  
4. Align the receiver's keyhole slots  
with the screw heads and slide the  
receiver down to secure it.  
• Keep the system dry. If it gets wet,  
wipe it dry immediately.  
• Use and store the system only in  
normal temperature environments.  
OPERATION  
• Handle the system gently and care-  
fully. Do not drop either component.  
Your caller presses BELL on the door  
transmitter to sound the receiver’s  
chime.  
• Keep the system away from dust  
and dirt, and wipe the system with a  
damp cloth occasionally to keep it  
looking new.  
Note: If the chime sounds when the  
transmitter's button is not pressed,  
change the channel settings on both the  
receiver and transmitter.  
Modifying or tampering with the sys-  
tem’s internal components can cause a  
malfunction and invalidate its warranty.  
If your system is not performing as it  
should, take it to your local RadioShack  
store for assistance.  
Hold down TALK on the receiver (the red  
indicator lights) and speak in a normal  
tone into the transmitter’s microphone  
from about 2–3 inches away. When you  
release TALK, the caller can reply by  
holding down TALK on the transmitter.  
THE FCC WANTS YOU TO  
KNOW  
Notes:  
Your chime system might cause TV or  
radio interference even when it is oper-  
ating properly. To determine whether  
the system is causing the interference,  
remove the transmitter’s battery or un-  
plug the receiver from AC power. If the  
interference goes away, the transmitter  
or the receiver is causing the interfer-  
ence. Try to eliminate the interference  
by moving the TV or radio away from the  
transmitter or contacting your local Ra-  
dioShack store for help. If you cannot  
eliminate the interference, the FCC re-  
quires that you stop using the system.  
• The receiver and transmitter auto-  
matically turn off if no one presses a  
button within about 30 seconds.  
Pressing any button on either unit  
turns on the power again.  
• If the temperature approaches the  
lower end of the intercom’s operat-  
ing range (around 0°F), you might  
notice some sound distortion. This is  
not a malfunction.  
• A wireless telephone operating at  
49MHz can interfere with the sys-  
tem.  
5
 
63-984.fm Page 6 Wednesday, September 8, 1999 4:42 PM  
Dimensions (HWD):  
Changes or modifications to this product  
not expressly approved by RadioShack,  
or operation of this product in any way  
other than as detailed by this Owner’s  
Manual, could void your authority to op-  
erate the product.  
7
7
7
16  
16  
16  
6 / × 3 / × 1 / in  
(163 × 88 × 36 mm)  
7
16  
Weight .............................................. 7 / oz  
(210 g)  
RECEIVER  
Channel Frequency:  
ChannelA ........................... 49.860 MHz  
ChannelB ........................... 49.890 MHz  
SPECIFICATIONS  
TRANSMITTER  
Operating Temperature Range:  
32° to 109.4°F (0° to 43°C)  
Operating Voltage .............................. DC 6V  
Power Requirements ......... AC 120V, 60 Hz  
Current ............................ 25mA (maximum)  
Dimensions (HWD):  
Channel Frequency:  
ChannelA ........................... 49.860 MHz  
ChannelB ........................... 49.890 MHz  
Operating Temperature Range:  
–0.4° to 140°F (–18° to 60°C)  
9
3
15  
16  
8
16  
5 / × 4 / × 1 / in  
(142 × 111 × 50 mm)  
Transmission Range .............. About 50 feet  
(15.24 m)  
1
2
Weight ............................................. 15 / oz  
(440 g)  
Specifications are typical; individual units  
might vary. Specifications are subject to  
change and improvement without notice.  
Power Requirements... 4 × 1.5V AA batteries  
Alkaline Battery Life ...................... 6 months  
Limited One-Year Warranty  
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one (1) year  
from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS  
PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE  
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE  
WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABIL-  
ITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR  
DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY  
BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE,  
LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL  
DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.  
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of incidental or consequential damages,  
so the above limitations or exclusions may not apply to you.  
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as proof of purchase date  
to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law: (a) correct the defect by product repair with-  
out charge for parts and labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase price. All re-  
placed parts and products, and products on which a refund is made, become the property of RadioShack. New or reconditioned parts  
and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the re-  
mainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the war-  
ranty period.  
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, misuse, improper or ab-  
normal usage, failure to follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess volt-  
age or current; (b) any repairs other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as fuses  
or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up  
service adjustment or reinstallation.  
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.  
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102  
We Service What We Sell  
04/99  
09A99  
Printed in Hong Kong  
 

Radio Shack Microphone 32 1230A User Guide
Ricoh Photo Printer MP C300 User Guide
RIDGID Metal Detector Metal Detector User Guide
Rosewill Network Card RNX N300 User Guide
Samsung Fax Machine SF 110T User Guide
Samsung Flat Panel Television 5 Series User Guide
Samsung Indoor Furnishings WE357A0P User Guide
Samsung Projector SP P410M User Guide
Saturn Automobile 2009 VUE User Guide
Sears Cordless Drill 1032313 User Guide